Low profile push-fit filler plug TPB-TPBS-TPBSF

The flat pressure cap is made of polyamide 66. Maximum working temperature +100°C.
Press fit into the hole per ‘F’ values given in the table with a tolerance of -0 +0.1mm with 1mm/45° chamfer.
O-ring NBR 70 shore.
The models with breather allow high levels of air renewal. The filter included in the corresponding models is made of polyurethane foam PPI60.
The low profile of the plug makes it very suitable for places where the space above the plug is limited.

1 = Air filter
2 = O-Ring